User Manual
Table Of Contents
- Restore Default Settings
- Exit Setup without Changes
- Set Connection
- RF Auto Shutdown Duration
- Memory Mode Parameters
- List Setting
- Buzzer Settings
- Reading Redundancy Setting
- Scan Mode Setting
- Auto-Sense Setting
- Scanner Time-out Duration
- Negative Barcode Setting
- Delay between Reread
- Keyboard Wedge Parameters
- Laptop Support
- RS-232 Parameters
- Bluetooth Serial Port Parameters
- Prefix / Postfix Settings
- Character Substitution
- Code ID Selection
- Code ID Setting
- Length Code Setting (2 digits)
- Code 39 Length Code
- Italy Pharmacode Length Code
- French Pharmacode Length Code
- Industrial 25 Length Code
- Interleave 25 Length Code
- Matrix 25 Length Code
- Codabar Length Code
- UPCA Length Code
- UPCE Length Code
- EAN8 Length Code
- EAN13 Length Code
- Code 93 Length Code
- Code 128 Length Code
- EAN128/RSS Length Code
- MSI Length Code
- Plessey Length Code
- Telepen Length Code
- Select Readable Codes
- Code39 Parameters
- Italy Pharmacode Parameters
- French Pharmacode Parameters
- Industrial 25 Parameters
- Interleave 25 Parameters
French Pharmacode Parameters
• Max / Min Code Length Qualification
• Checksum Transmission
Select Max / Min Length Qualification
< Enable >
Disable
Max Length *
Min Length *
Industrial 25 Parameters
• Fixed Code Length Qualification
• Start / Stop Selection
Select Fixed Length Qualification
< Industrial 25 >
Interleave 25
Matrix 25
Fixed Length 1 *
Fixed Length 2 *
Programming Instructions : (1) Read the label. (2) Program the desired length by
reading Decimal Digits on page 49. (3) Read the “Validate” label (also on page 49)
to complete this setting.
• Checksum Verification
Enable
< Disable >
Interleave 25 Parameters
• Start / Stop Selection
• Checksum Transmission
Industrial 25
< Interleave 25 >
Matrix 25
< Enable >
Disable
24
Enter Setup
23
Update