User's Manual

Cipherium Repeater
Administrator’s Manual
57
Layer2 Client Isolation: You can enable this function to isolate two different domains or just
Disable from system default.
EX:10.2.3.4 can’t see 10.2.4.4
Figure 5-35 Wireless Port Configuration(2)
IP PNP: At the user end, you can use any IP address to connect to the machine at the
Public LAN section; no matter what the IP address at the user end is, you can obtain the
Public LAN from Repeater and access the network resources properly, suppose you used static
IP address and specified IP address, Subnet Mask, Default Gateway and DNS.
User Public LAN: You can choose to Enable or Disable user Public LAN, if you enable user
authentication, you have to define Specific Route Profile to user.
Specific Route Profile: To define specific route for user to access network.
Operation Mode: It provides two modes: NAT Mode and ROUTER Mode.
IP Address: Enter your desired IP address for setup.
Subnet Mask: Enter your desired Subnet Mask for setup.
Related Setup for DHCP Server of Public LAN. DHCP Server has three choices: Disable