User's Manual

Cipherium Repeater
Administrator’s Manual
32
functions include: Configuration Wizard, System Information, WAN Configuration,
Authentication Configuration, and Private LAN Configuration. Please refer to the explicit
setup if you need more information.
5.1.1. Configuration Wizard
The Wizard will guide you through the setup of Repeater1200. All you need is to follow the
procedures and instructions given by the Wizard, step by step, fill in the required set values.
And, then restart Repeater to activate the setting.
Please click the “Run Wizard” button on the Setup Wizard interface as shown in Figure 5-1
to start the system setup.
Figure 5-1 Setup Wizard Interface
The Setup Wizard Interface as shown in Figure 5-2 describes the installation procedure, and
there are 9 procedures as listed below:
1. Change Admin Password
2. Choose System’s Time Zone
3. Set System Information
4. Select the Connection Type for WAN Port
5. ConfigureAuthentication Information
6. Select Authentication Methods
7. Set Wireless – Access Point Connection
8. Configure Wireless Port’s Information
W 5101
W 5101