User's Manual

Cipherium Repeater
Administrator’s Manual
27
4. Console Interface
The interface of Repeater provides two types of function,
A. The Repeater provides a RJ11 interface for the administrator to handle different problems
and situations occurred during operation. To link to the RJ11 interface of the Repeater, you
need a modem cable. The terminal simulation program that you use, such as the super
terminal, should be set to the parameter value of 9600,8,n,1.
The main console is a basic interface using interactive dialog boxes. Please use the arrow
keys on the keyboard to browse the menu and press the “Enter” key to select specific
menus and confirm entered value.
B. It also can be as a printer interface that connects to specific thermal line ticket printer.
Warning: These two functions can’t be used at the same time.
4.1. Main Menu of Console interface
Once you properly connect to the serial port of the Repeater, the console welcome screen will
appear automatically. If the welcome screen does not appear in the terminal simulation
program automatically, please try to press the “Down” arrow key, so that the terminal
simulation program will send some commands to the serial port of the Repeater, and the
welcome screen or the main menu will appear again. If you are still unable to see the welcome
screen or the main menu of the console, please check if the connection of your cables and the
setup of the terminal simulation program are correct.
Figure 4-1 Main Menu of Repeater Console Interface
W-5101