User's Manual

Cipherium Repeater
Administrator’s Manual
20
3.2.3. Begin Installation
After the Repeater is connected to network devices, you can start setting the Repeater to
control your network environment. In the following sections, we will guide you step by step
to set up a system composed of individual Repeater.
3.2.3.1. Entering the Web Management Interface
1. Opening Browser
After the Repeater is installed and the foregoing setup is completed, use the network cable of
the 10/100BaseT to connect to the Private LAN port, please open the browser (such as
Microsoft IE). On the website, enter the administrator’s URL such as https://192.168.2.254
.
IF you can’t get the login screen, this may because you have set your network to obtain an IP
address automatically from Private LAN port and this IP address does not belong in the same
subnet as this URL, please specify an IP address such as 192.168.2.xx in your network then
do it again.
2. Keying in the Administrator’s Username and Password
In the opened webpage, you will see the login screen as shown in Figure 3-3. Please key in
“admin” in the Username column, and then “admin” in the Password column. Click “Enter”
to login.
Figure 3-3 Administrator Login