User's Manual

Cipherium Repeater

Administrator’s Manual

use the cross over line.

Warning: Public LAN cannot connect to Layer 3 device.

5. Connect the Private LAN port.

The Private LAN port is used to connect the trustful network or Ethernet. In other words, the

computer connected to the Repeater from Private LAN does not require login to use the

network resources. This port can be used to connect to a server such as File Server or a

DataBase Server, etc. Use the network cable of the 10/100BaseT to connect to the Switch or

Hub of the Private LAN, and then use the network cable of the 10/100BaseT to connect to the

Administrator’s PC. If it is necessary to connect the PC or wireless AP directly to the Private

LAN, then we need to use the cross over line.

6. Turn on the power.

Plug the bundled power supply connector into the socket.

7. Check the LED indication light.

After the power is on, the power indication light should be lit. The WAN and indication lights

should be lit when the WAN and ports are properly connected to the network equipment. The

corresponding indication lights also should be lit when the Public LAN and Private LAN ports

are properly connected.

3.1.3. Setting up the PC for the Public LAN and Private LAN

After the Repeater is installed, the following must be set up for the Public LAN and Private

LAN sections:

 TCP/IP Network Setup

 Internet Connection Setup