User's Manual

Cipherium Repeater
Administrator’s Manual
8
3. Installation
3.1. Installing the Repeater
3.1.1. System Requirements
 Standard 10/100BaseT including four network cables with RJ-45 connectors.
 All PCs need to install the TCP/IP network protocol.
3.1.2. Installation Procedure
Follow the following steps to install the Repeater:
1. Make sure the power of the Repeater is turned off.
2. Connect the WAN port.
Use the network cable of the 10/100BaseT to connect to the Repeater and the network not
managed by the Repeater system such as the ATU-Router of ADSL, port of Cable Modem, or
the Switch or Hub on the LAN of a company.
3. Connect the port. (Optional)
Use the network cable of the 10/100BaseT to connect to the Repeater and the network not
managed by the Repeater system such as the ATU-Router of ADSL, port of Cable Modem, or
the Switch or Hub on the LAN of a company.
4. Connect the Public LAN.
The Public LAN is used to connect the desired network for management or WLAN, and all
users connected to the Public LAN must login successfully before using the network resources.
Use the network cable of the 10/100BaseT to connect to the Switch or Hub of the Public LAN,
and then use the network cable of the 10/100BaseT to connect to the Administrator’s PC. If
it is necessary to connect the PC or wireless AP directly to the Public LAN, then we need to