User's Manual

W1310R
User’s Manual
45
3. CTS Protection Mode: The default value is Disable. When enabled, a protection mechanism will ensure
that the 802.11b devices can connect to Access Point and not be affected by many other 802.11g devices
existing at the same time. However, the performance of this 802.11g devices may decrease.
4. Basic Rate: The basic rate offers three options, All, Set1 and Set2 and the default value is Set1.
Depending on the wireless mode selected, W1310R will deliver a pre-defined data rate. Select “All” to
activate all transmission rates to be compatible with the majority of the devices.
5. Beacon Interval: Enter a value between 20 and 1000 msec. The default value is 100 milliseconds. The
entered time means how often the signal transmission occurs between the access point and the wireless
network.
6. RTS Threshold: Ready To Send threshold. The range is from 256 to 2346 and the default is OFF. The
administrator could set the value which is the time to wait before sending another packet. It is recommended
that the value remains in the range of 256 to 2346.
7. Fragmentation Threshold: The range is from 256 to 2346 and the default is OFF. The value specifies the
maximum size of packet allowed before data is fragmented into multiple packets. It should be remained in
the range of 256 to 2346. A smaller value results smaller packets but with a larger numbers of packets in
transmission.
8. DTIM Interval: This function indicates the interval of the Delivery Traffic Indication Message (DTIM). DTIM
is a countdown function to inform clients to listen to broadcast and multicast messages. When an Access
Point has buffered broadcast or multicast message from an associated client, it sends the next DTIM at this
interval rate (from 1~255), the client will hear the beacons.
 Wireless Configuration
IP PNP: Use any IP address to connect to the system. Regardless of what the IP address at the users end is,
they can still be authenticated through W1310R and access the network.
User Authentication: If “User Authentication” is disabled, “Specific Route Profile” needs to be specified for
the users to access Internet.
Operation Mode: Choose one of the two modes, NAT mode and Router mode, by the requirements.
IP Address: Enter desired IP address for the wireless port.
Subnet Mask: Enter desired subnet mask for the wireless port.