User's Manual

W1310R

User’s Manual

 DHCP Server Configuration

There are three methods to set the DHCP server: Disable DHCP Server, Enable DHCP Server and Enable

DHCP Relay.

1. Disable DHCP Server: Disable DHCP Server function.

2. Enable DHCP Server: Choose “Enable DHCP Sever” function and set the appropriate configuration for

the DHCP server. The fields with red asterisks are required to be filled in.

DHCP Scope: Enter the “Start IP Address” and the “End IP Address” of this DHCP block. These fields

define the IP address range that will be assigned to the Private LAN clients.

Preferred DNS Server: The primary DNS server for the DHCP.

Alternate DNS Server: The substitute DNS server for the DHCP.

Domain Name: Enter the domain name.

WINS IP Address: Enter the IP address of WINS.

Lease Time: Choose the time to update the DHCP.

Reserved IP Address List: For reserved IP address settings in detail, please click the hyperlink of

Reserved IP Address. If using the Reserved IP Address List function for IP address outside the DHCP

range is desired, click the Reserved IP Address List on the management interface. The setup of the

Reserved IP Address List as shown in the following figure will appear. Enter the related Reserved IP

Address, MAC, and some description (not mandatory). Click Apply to complete the setup.