Manualshelf

User's Manual

ManualsBrandsCipherium System ManualsElectronicsIEEE802.11 b/g AP
31323334353637383940
W1310R
User’s Manual
37
LAN1 & LAN2 Port
IP PNP: Users can use static IP address to connect to the system. Regardless of what the IP address at the user
end is, users can still be authenticated through W1310R and access the network.
User Authentication: Choose to enable or disable this function. If “User Authentication” is disabled, users
can access Internet without being authenticated.
Operation Mode: Choose one of the two modes, NAT mode and Router mode, by the requirements.
IP Address: Enter the desired IP address for the LAN1 & LAN2 port.
Subnet Mask: Enter the desired subnet mask for the LAN1 & LAN2 port.
DHCP Server Configuration
There are three methods to set the DHCP server: Disable DHCP Server, Enable DHCP Server and Enable
DHCP Relay.
1. Disable DHCP Server: Disable DHCP Server function.
2. Enable DHCP Server: Choose “Enable DHCP Sever” function and set the appropriate configuration for
the DHCP server. The fields with red asterisks are required to be filled in.