Owners manual

Rev. 2 12/04 nml Document #700187
page 3 of 3
STEP FOUR
Installing Xtendable Trailer Tow Mirror
Clean any foreign material from sheet metal of door
exterior with a clean, soft cloth.
If you are installing an electric mirror, feed the wire
harness through the center hole in the door.
Slide the three studs on the mirror into the holes in
the door. While a second person holds the mirror in
place, thread a 10mm nut from the parts kit onto
each stud. Once the nuts are installed on each
stud, tighten them in an alternating pattern until
they are secure.
STEP FIVE
Reconnecting Electric Mirror
If installing an electric mirror, connect the wiring
harness to the plug in the door and slip the wiring
into the door cavity. Note: some mirrors have a four
inch jumper harness assembled for adaptation of a
non heated mirror to a heated harness. Discard this
jumper harness if your vehicle does not have heat.
S
TEP SIX
Finishing Installation
Replace the gasket in the opening in the door and
reinstall the trim piece with the christmas tree fas-
tener.
View from Outside Vehicle
View from Inside Vehicle
Feed Wire Harness
through hole
Align Studs with
holes in door
Install 10mm
Nuts
Wiring
Harness
Reinstall Trim Piece
Reinstall
Trim Piece
Reinstall
Gasket
STEP SEVEN
Repeat this installation procedure with the remain-
ing mirror on the other side of the vehicle.
This completes the installation of your Towing
Mirror.