Owners manual

Rev. 2 12/04 nml
page 2 of 3
Document #700187
STEP ONE
Removing Trim Piece and Stuffer Gasket
Open the door and roll the window completely
down.
Start at the top edge of the corner door trim piece
and gently pull away and down from the door to
disengage the christmas tree. Once disengaged,
pull the trim piece upward to disengage it from the
door trim panel.
Gently pull the gasket from door pocket .
Set both pieces aside to be reinstalled later.
STEP TWO
Disconnecting Electrical Connector –
Electric Mirrors Only
For manual mirror installation proceed to Step Three.
If you are installing an electric mirror, pull the wiring
harness out of the door to access the plug. Gently
pry the locking tab on the side of the plug and pull
the harness away. DO NOT allow the harness and
connector to fall into the door cavity.
STEP THREE
Removing Factory Mirror
While a second individual holds the factory mirror,
use a 10mm open ended wrench to remove the the
three 10mm nuts inside the door. Make sure not to
drop loose 10mm nuts into door cavity. Slowly
remove factory mirror from door.
If the vehicle is equipped with an electrical harness
feed it through as the mirror is removed.
Note: Two people are required for proper installation of this product.
Remove Trim Piece
Roll Window Down
Remove
Trim Piece
Remove
Gasket
Wiring
Harness
Remove
10mm Nuts
Area of Detail