Owners manual

Rev. 2 12/04 nml Document #700187

page 1 of 3

Xtendable Trailer

Towing Mirror

Installation Instructions

For: All General Motors C/K Trucks1988-2000*

WARNING

Manufacturer recommends this installation be

carried out by a professional installer or your

local dealership.

PLEASE read ALL INSTRUCTIONS and

warnings carefully before installing this prod-

uct. These mirrors are designed only for the

vehicle listed on this page. Ensure that the fit-

ting instructions are followed exactly, as failure

to do so may result in incorrect installation, or

result in the driver, passenger or vehicle being

placed in a hazardous condition, as well as

voiding any warranty, implied or otherwise.

PARTS LIST

Driver’s Side Mirror

Passenger Side Mirror

10mm Nut

10mm Wrench

Installation Instructions

* Chevrolet Years

CK Pickup 1988-2000

Suburban 1992-1999

Tahoe 1995-1999

Tahoe Limited

2000

GMC Years

Sierra 1988-2000

Suburban 1992-1999

Yukon 1992-1999

Denali 1998-2000

CIPA Part Numbers 70000, 70500 & 80000

PAGE 1
Xtendable Trailer Towing Mirror Installation Instructions For: All General Motors C/K Trucks1988-2000* * Chevrolet Years CK Pickup 1988-2000 Suburban 1992-1999 Tahoe 1995-1999 Tahoe Limited 2000 GMC Sierra Suburban Yukon Denali Years 1988-2000 1992-1999 1992-1999 1998-2000 WARNING Manufacturer recommends this installation be carried out by a professional installer or your local dealership.
PAGE 2
Note: Two people are required for proper installation of this product. STEP ONE Removing Trim Piece and Stuffer Gasket Open the door and roll the window completely down. Remove Trim Piece Roll Window Down Start at the top edge of the corner door trim piece and gently pull away and down from the door to disengage the christmas tree. Once disengaged, pull the trim piece upward to disengage it from the door trim panel. Remove Gasket Gently pull the gasket from door pocket .
PAGE 3
STEP FOUR Feed Wire Harness through hole Installing Xtendable Trailer Tow Mirror Clean any foreign material from sheet metal of door exterior with a clean, soft cloth. If you are installing an electric mirror, feed the wire harness through the center hole in the door. Install 10mm Nuts Slide the three studs on the mirror into the holes in the door. While a second person holds the mirror in place, thread a 10mm nut from the parts kit onto each stud.