Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 Sample Application
- 3 Operating Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
PLS62-W Hardware Interface Overview
2.1 Application Interface
29
t PLS62-W_hio_v02.010a 2020-08-18
Public / Released
Page 16 of 50
Figure 5: Module’s two UICC/SIM/USIM interfaces
Figure 6: UICC/SIM/USIM interfaces connected
The total cable length between the SMT application interface pads on PLS62-W and the pads
of the external SIM card holder must not exceed 100mm in order to meet the specifications of
3GPP TS 51.010-1 and to satisfy the requirements of EMC compliance.
To avoid possible cross-talk from the CCCLKx signal to the CCIOx signal be careful that both
lines are not placed closely next to each other. A useful approach is using the GND line to
shield the CCIOx line from the CCCLKx line.
SIM1
1
st
SIM interface
SIM2
Module
2
nd
SIM interface
Module
open: Card removed
closed: Card inserted
CCRSTx
CCVCCx
CCIOx
CCCLKx
CCINx
SIM /
UICC
1n
220n
SMT application interface
GND