Installation Guide

Resetting the LINK 740
If your LINK 740 does not operate properly or signals a system error you may need to restart or reset the
unit. Only restart or reset the LINK 740 after you have made sure you have carried out all previously de-
scribed steps without success.
Restarting your LINK 740
To restart your LINK 740, press the reset button with a thin pointed object until it clicks and keep it pressed
down for 1 to 2 seconds. The LINK 740 restarts within approximately five seconds after releasing the but-
ton.
If restarting the device does not succeed remove the Power/CAN cable from the LINK 740. Then plug it into
the Power/CAN cable connector again.
Resetting your LINK 740 to factory settings
To reset the LINK 740 to factory settings, press the reset button with a thin pointed object until it clicks and
keep it pressed until the green LED starts flashing rapidly. The LINK 740 reboots within approximately five
seconds after releasing the reset button.
Important: All information stored on the LINK 740 is deleted during a factory reset.
24