Specifications

Cinterion
®
EHS5-E/EHS5-USR4 Hardware Interface Overview
5.4 Compliance with FCC and IC Rules and Regulations
38
 ehs5_hio_v04.000 2019-01-16
Confidential / Preliminary
Page 38 of 46
5.4 Compliance with FCC and IC Rules and Regulations
The Equipment Authorization Certification for the Gemalto M2M reference application de-
scribed in Section 5.3 will be registered under the following identifiers
1
:
FCC Identifier: QIPEHS5-USR4
Industry Canada Certification Number: 7830A-EHS5USR4
Granted to Gemalto M2M GmbH
Manufacturers of mobile or fixed devices incorporating EHS5-USR4 modules are authorized to
use the FCC Grants and Industry Canada Certificates of the EHS5-USR4 modules for their own
final products according to the conditions referenced in these documents. In this case, an FCC/
IC label of the module shall be visible from the outside, or the host device shall bear a second
label stating "Contains FCC ID: QIPEHS5-USR4", and accordingly “Contains IC: 7830A-
EHS5USR4“. The integration is limited to fixed or mobile categorised host devices, where a sep-
aration distance between the antenna and any person of min. 20cm can be assured during nor-
mal operating conditions. For mobile and fixed operation configurations the antenna gain,
including cable loss, must not exceed the limits 3.10 dBi (850 MHz) and 2.50 dBi (1900 MHz).
IMPORTANT:
Manufacturers of portable applications incorporating EHS5-USR4 modules are required to
have their final product certified and apply for their own FCC Grant and Industry Canada Cer-
tificate related to the specific portable mobile. This is mandatory to meet the SAR requirements
for portable mobiles (see Section 5.2 for detail).
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules and with Industry Canada licence-exempt RSS
standard(s). These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
If Canadian approval is requested for devices incorporating EHS5-USR4 modules the above
note will have to be provided in the English and French language in the final user documenta-
tion. Manufacturers/OEM Integrators must ensure that the final user documentation does not
contain any information on how to install or remove the module from the final product.
1. Applies only for the quad band module variant EHS5-USR4.