User guide

Introduction
Thank you for choosing an SA505 Bluetooth® Stereo Headset from Cingular, powered by SouthWing.
This user guide provides all the information you will need to use and care for your product.
All relevant information regarding your SouthWing product can be found on the support section of our website:
www.south-wing.com/cingular-sa505
1. Charging the Headset
You will need to charge the battery of your Headset. To do so, follow these steps:
1. Make sure the Headset is turned off.
2. Plug the power supply into a power point.
3. Plug the connector of the power supply into the USB Charging Socket [1]. The Charging Light [3] will turn red to
indicate the Headset battery is charging.
4. Once the Charging Light [3] turns off, the Headset is fully charged and can be removed from the power supply.
USB charging
The Headset battery can be charged from any USB port, such as those found on a PC or laptop, by using the SouthWing
USB cable adaptor accessory available for purchase on the SouthWing website.
Please Note:
• The Headset will not function while charging.
• If the Charging Light [3] remains off when charging, the battery is already fully charged and does not require further
charging.
• To maximize battery life, do not charge the Headset for extended periods of time.
• Full battery capacity will be achieved after two or three full charge/discharge cycles.
• When your battery is empty, it takes up to three hours to completely charge your Headset.
• Use only the power supply provided by SouthWing or by Cingular in Cingular packaging labeled as compatible with the
SouthWing SA505 Headset.
2. Turning the Headset on and off
Before turning the Headset on, make sure the microphone is in the retracted position as in Figure 2. The first
time the Headset is turned on, it is already in pairing mode, please refer to Auto-pairing section below. To turn
the Headset on, move the Power switch [2] to the ON position. A short tone will be heard and the Status Light [10] will
start flashing slowly in red. When the Headset is turned on, it will automatically connect to the last phone and stereo music
devices that were connected.
To turn the Headset off, move the Power switch [2] to the OFF position.
3. Pairing the Headset
Auto-pairing
For added convenience, your Headset has an auto-pairing function so that when you turn the Headset on for the first time,
it is already in pairing mode. The Status Light [10] will flash blue and red alternately and 2 short tones will be heard. Then,
follow these steps:
1. Put the other Bluetooth device into pairing mode (see the instructions which came with your device). Ensure that the
Bluetooth device is no more than 3 feet (1 meter) away from the Headset.
2. Enter the PIN number (four zeros): 0000.
If pairing is successful, the Status Light [10] will flash slowly in blue.
Normal pairing
You will need to follow the steps below if you want to pair your Headset with another Bluetooth device. Your Headset will
store the pairings of 5 devices. You may pair to more devices, but each new device will replace a previously paired device.
1. Make sure the microphone is in the retracted position as in Figure 2.