User`s manual

NexSens Technology, Inc.
iSIC User‟s Manual 67
3.4 Changing iSIC Configuration and Setup
3.4.1 iSIC Configuration and Setup
After a project has been setup, there are two ways to change the configuration and setup.
To add new project information, select Project | Setup Device Wizard from the iChart menu.
This will open the iChart wizard to add new project information.
To change existing sensors and data logger configuration, right click on the data logger or sensor
in the navigation panel and select Property.
This will open the specific devices information and allow you to:
 Change the site name and description in the Property selection of sites.
 Change the iSIC address and COM port used by iChart to communicate with a data
logger in the Property selection of data loggers.
 Change sensor parameters, ranges, ports, and other sensor information in the Property
selection of sensors.
 Change parameter names, units of measure, and scaling in the Property selection of
parameters.