User`s manual

NexSens Technology, Inc.
iSIC User‟s Manual 22
Checking APN and context values:
After a Cingular EDGE 3100-iSIC data logger is received it will need to be activated with the
account information as detailed in this section.
Connect the 3100-iSIC modem:
4. Connect the supplied A77 3100-iSIC modem programming cable to an open PC COM port
and the modem cable as indicated in the picture on the following page.
5. Attach the antenna and RF cable to the N-style connector on the 3100-iSIC enclosure
6. Apply power to the iSIC and run Wireless ACE 3G software, following the steps detailed in the
next section.
Note: If the PC you are using does not have a COM port you can use a USB to COM port adapter,
which can be obtained at a local Radio Shack.
After receiving the necessary information from your service provider and all phone
numbers or IP addresses are activated, install the software program Wireless
ACE 3G. This program is included with your cellular modem in the 3100-iSIC
AT&T Companion CD located at http://www.nexsens.com/support/downloads.htm
and all settings and options of the modem can be accessed using it.
Note: Wireless ACE 3G is also available for download at www.sierrawireless.com.
***Note: do not perform these steps if a cellular account has not yet been setup***