User`s manual

NexSens Technology, Inc.
iSIC User‟s Manual 20
Testing Settings:
The wizard will now test all connection settings. All green check marks should appear after a few
moments. If the modem fails to successfully complete this step, double check the device
activation information
If you see the “Failed to reset the modem automatically” error, but there is a green check box in
each field and the wizard says “Congratulations..”, click OK, close the wizard, reset power to the
iSIC by removing the two fuses. The Setup Wizard is complete and the modem is programmed.
The 3100-iSIC cellular modem is now programmed and ready for use with environmental
sensors. Click Finish and cycle power to the modem by removing the two fuses located inside of
the iSIC enclosure and then placing them back in. Please refer to both Chapter 4 and Appendix E
for further instructions on configuring specific sensors.