User`s manual

NexSens Technology, Inc.
iSIC User‟s Manual 19
Checking Signal Strength:
The wizard will now make sure you have sufficient signal strength to provision the modem. Make
sure the antenna is connected and the modem is in a good location to receive a cellular signal. If
you are indoors try moving towards a window or to a place that receives a cellular signal. Since
the information required to activate the modem is downloaded, you will need to have sufficient
signal strength to proceed. Click Next to proceed.
If low signal strength is detected, make sure the antenna is securely attached to the 3100-iSIC
and the RF cable is not cut, damaged, or bent sharply.
Next the wizard will provision the modem.
If you see the “Failed to reset the modem automatically” error, click OK, close the wizard, reset
power to the iSIC by removing the two fuses and start the Setup Wizard over.