User guide

Pocket Verifier • Smartphone Edition • User Guide and Tutorial 9 of 27
Pairing the Pocket Spectrum
Before using the Pocket Spectrum with Pocket Verifier you must first pair it to your
phone. Once the Pocket Spectrum is paired, you will not need to perform these steps
again unless you pair the Pocket Spectrum to another device (for security reasons the
Pocket Spectrum can only be paired to one device). If you hard reset you phone on
Pocket Spectrum, then you will also need to reset up the connection.
It is recommended that both your phone and Pocket Spectrum are fully charged before
performing these steps.
Note: The Pocket Spectrum may be recognized as MPS5B0079 or a similar name.
Reset the Pocket Spectrum
1. If the Pocket Spectrum is on, turn it off.
2. Turn the Pocket Spectrum by pressing a hold the on button for 3 seconds.
You will hear a series of beeps and the Pocket Spectrum will print out a
diagnostic sheets. Once this is done, the Pocket Spectrum is ready for pairing to a
new device.
Setup a Bluetooth Connection with your Phone
1. Turn on your phone
2. Press the top button located at the top left spine of the
phone. This opens the Communications Manager.
3. Select Settings > Bluetooth Settings…
4. Under the Bluetooth heading select On.
5. Select Menu > Devices.
A list of Bluetooth devices will appear here.