User manual

9.0 MISCELLANEOUS
46 R599810 - Blackwing mk2012 User Manual
• DHCP Client: When set to ON, the projector’s IP address will be automatically set by the DHCP server. on the
LAN.
• IP Address: Sets the IP (Internet Protocol) address of the projector. A valid address must be set for this unit.
• Subnet Mask: Sets the Subnet Mask
• Default Gateway: Sets the Default IP Gateway of the projector.
•MAC Address: A 6 byte hex number that uniquely identifies the projector on the LAN. The value is unique to
each individual unit on the LAN network.
The first step to verify that the network configuration of this unit has been correctly set is to ping the projector from a
computer on the network using the command prompt.
Sending a LAN Control Command
In order to send a Remote Control compatible command to this unit, you must open a TCP connection on port
20554. and send a command immediately as the connection will be dropped within 5 sec of inactivity.. If for any
reason you have to change the TCP connection port, you may use the following RS-232c/LAN command.
[4Ch 53 50h 54h] + 4 ASCII chars as new port adress in hexa
LAN communication protocol and timed out
Examples
You want to set TCP port to 10000 Command to send (RS-232C)
Send 10000 as new TCP port value:
10000 is 2710h in hexa, converted in
ASCII characters: 32h 37h 31h 30h
send: 21h 89h 01h 4Ch 53h 50h 54h 32h 37h 31h 30h 0Ah
receive: 06h 89h 01h 4Ch 53h 0Ah (confirm cmd)
Then, reboot Network module
send: 21h 89h 01h 4Ch 53h 52h 53h 0Ah
receive: 06h 89h 01h 4Ch 53h 0Ah (confirm cmd)
You want to... Command to send
Switch the projector ON
1. open TCP connection
2. receive PJ_OK : 50h 4Ah 5Fh 4Fh 4Bh
3. send PJREQ: 50h 4Ah 52h 45h 51h
4. receive PJACK: 50h 4Ah 41h 43h 4Bh
5. send Power On cmd: 21h 89h 01h 52h 43h 37h 33h 30h 35h 0Ah
6. receive confirmation: 06h 89h 01h 52h 43h 0Ah
after 5 sec, TCP connection is closed.
Switch Anamorphic to mode A
1. open TCP connection
2. receive PJ_OK: 50h 4Ah 5Fh 4Fh 4Bh
3. send PJREQ: 50h 4Ah 52h 45h 51h
4. receive PJACK: 50h 4Ah 41h 43h 4Bh
5. send Anamorphic A: 21h 89h 01h 52h 43h 37h 33h 32h 33h 0Ah
6. receive confirmation: 06h 89h 01h 52h 43h 0Ah
after 5 sec, TCP connection is closed.
Control Device
Projector
1. Openning Connection
2. Projector Ready
3. Command Type
(PJREQ)
(PJ_OK)
4.Projector Acknoledge
(PJACK)
5. Command
6. Projector confirms
After 5sec, connection
is closed.
on port 20554