User manual

7.0 ANAMORPHIC SETUPS
36 R599810 - Blackwing mk2012 User Manual
7.3 Installing a Motorized Anamorphic Lens
Plug the 12V Trigger output of the projector to the Anamorphic motorization
Connect the lens motorization to the 12V Trigger output
Configure into Function “Menu ⇒⇒
⇒⇒
Trigger ⇒⇒
⇒⇒
On (Anamo)”
The “Function ⇒⇒
⇒⇒
Tr igger” menu determines the 12V Trigger output located in the panel input at the rear of this unit.
This is a global parameter (for all inputs):
• Off: the 12V Trigger is always switched Off.
• On (Power): the 12V Trigger is switched On when the projector is running, Off if the projector is in standby Mode.
• On (Anamo): the Trigger is Off and switches when the picture is vertically stretched and the lens is needed.
Set 12V Trigger to: “Function ⇒⇒
⇒⇒
Tr igger ⇒⇒
⇒⇒
On (Anamo)”.
Video source is 16:9: set [Anamo]rphic to Off
When you select a 16:9 input choose the anamorphic OFF to obtain move the anamorphic lens out. Menu
“Installation ⇒⇒
⇒⇒
Anamorphic ⇒⇒
⇒⇒
Off”
Video source is Cinemascope: set [Anamo]rphic to Mode A
Select Anamorphic mode A for this input in the menu Input “Installation ⇒⇒
⇒⇒
Anamorphic ⇒⇒
⇒⇒
Mode A”.
The Anamorphic Lens is automatically placed in front of the projector to restore the correct picture aspect ratio.
12V Trigger
to anamorphic
motorization
Appearance
OFF
... press [Anamo] button to obtain the correct anamorphic mode.
When the source switches format...
on 2.35 screen
16:9 format
2.35:1 format
16:9 on 2.35 screen
2.35 on 2.35 screen
Mode A