User manual

6.0 MENU AND PICTURE SETTING
R599810 - Blackwing mk2012 User Manual 33
Menu Position
Upper left, Upper right, Center, Lower right, Lower left.
Menu Display
15sec: Display menu for 15 seconds before fade out.
On: Always display menu.
Line Display
5sec: Display the input settings for 5 seconds after input selection.
Off: Don’t display.
Source Display
On: Display the source of the input signals after input selection.
Off: Don’t display.
Logo
On: Display logo during startup for 5 seconds.
Off: Don’t display.
Language
Choose the OSD language between: English, Japanese, German, Spanish, Italian, French, Portuguese, Dutch,
Swedish, Norwegian, Russian and Chinese.
6.6 Function Menu
Trigger
The 12V trigger output can be used to control any compatible devices such as motorized screens or anamorphic
kits: The 12V trigger output is 12Vcc, 100mA. Select the trigger output behavior:
• Off: 12V trigger voltage state is always low.
• On (Power):12V trigger state is high when the projector is powered ON.
• On(Anamo): 12V trigger is high only when Anamorphic Mode A or Mode B is engaged. To be used with
anamorphic kits or motorized screens.
Off-Timer
You can configure this automatic power Off function that will switch off the projector when there is no operation or
after a determined timer. Choose the duration of the timer between: Off, 1 hour, 2 hours, 3 hours and 4 hours.
High Altitude Mode
Select this when the projector is in a location of low atmospheric pressure. On or Off.
Communication Terminal (BW2 & 3)
Sets on which input is connected the control device. It is not possible to use it at the same time both RS-232C and
LAN inputs. Settings: RS-232C, LAN.
Network (BW2 & 3)
When the Communication Terminal selected is LAN, this unit will be visible on the local Network and the following
parameters need to be configured. See “LAN protocol (BW2 & 3)”, page 45 for more details.
Remote Code
Select in the projector menu the code A or B according to the code selected on the RCU. You can change the code
used by the RCU to communicate with the projector from A to B. To do so, press simultaneously [MENU]+[BACK]
buttons on the RCU. All the buttons on the RCU will blink. Two blinks indicate that the B code is used, three blinks
indicates that A code is used.
Lamp Reset
Resets the lamp use time to "0" during the lamp replacement procedure. See “Replacing the Lamp”, page 37 for
more details.
6.7 Information Menu
Input Terminal