User manual

6.0 MENU AND PICTURE SETTING
28 R599810 - Blackwing mk2012 User Manual
Additionally, you can set the Clear Motion Demo side-by-side or top-and-bottom.
6.2.0.8 MPC Level
This setting adjust the increased resolution perception. Default setting for film,
cinema and THX profiles is 1, otherwise 2. Adjust between 0 and 3.
6.2.0.9 Lens Aperture
The lens is equipped with a variable electronic aperture. This function is used to
optically adjust the light output depending on the viewing conditions and the light
ambiance. Adjust from the correct aperture from partially closed to fully opened.
6.2.0.10 Lamp Power
Set the lamp power used by the current Picture Profile:
Normal: lamp is set to 160W
High: lamp is set to 220W.
To avoid any damage to the lamp, you can’t changed the lamp power within 90
seconds from the projector startup or 60 seconds after lamp power change.
Reset
Reset the current Picture Profile to default settings.
6.3 Input Signal menu
HDMI Inputs
This menu is available if the selected active input is HDMI1 or HDMI2.
6.3.0.1 Input
Auto: The input dynamic range is automatically detected and configured.
Standard: Force dynamic range to 16-235.
Enhance: Force dynamic range to 0-255.
Super White: Force dynamic range to 16-255.
6.3.0.2 Check Input Levels
The following pattern is overlaid to current picture to confirm that the correct input
level has been selected.
Use the Input Levels pattern to confirm the correct HDMI dynamic range setting.
6.3.0.3 Color Space
Auto: The source color space is automatically detected and configured.
YCbCr(4:4:4): Set color space to YCbCr 4:4:4.
YCbCr(4:2:2): Set color space to YCbCr 4:2:2.
RGB: Set color space to RGB 4:4:4.
6.3.0.4 Control with HDMI (CEC*)
Off: By default the CEC communications are disabled.
On: Enables CEC communications to be sent to the projector through HDMI cable.
*CEC stands for Consumer Electronic Control
Component
This menu is available if the selected active input is Component.
•Y Pb/Cb Pr/Cr: Select this option if the COMP. input is connected to a component video signal.
• RGB: Select this option if the COMP. input is used with a RGB video source.
PC (BW2 & 3 only)
This menu is available if the selected active input is PC (Sub-D15) input.
•Auto Alignment: Automatically adjusts Tracking, Phase and Picture Position
•Tracking: Adjust the horizontal size and display area of the picture.