User manual

12.0 APPENDIX: SPECIFICATIONS
R599791 - FORCE 3D User Manual 91
• Manual control 1/3 pixel fine movement control per button press on any applicable User Interface (e.g., remote).
• Calibration:
1) Automatic calibration on lens change detection
2) Automatic calibration on power-up
• User Configurable Calibration Modes
• Manual calibration
• Calibration time < 10 secs when required
• Bore sight 3-point +- 4 degrees adjustment and lockable without removing covers
•Travel time stop to stop
1) Zoom and Focus 10 sec nominal (depends on lens type)
2) Offsets 5 sec (nominal (depends on lens type)
• Manual Lens Movement Manual over-ride permissible for zoom and focus
Dynamic Iris
• Motorized iris with position feedback: Scene controlled motorized iris, adjusts to image content
• Max frequency open-close-open: 20Hz (20 times per second) < 2 frames for movie content
• Sound level: within ambient noise level of projector (inaudible)
• Configurable per channel
Automatic Fans
•Temperature sensitive fan speed control Fans automatically adjust to required speed to maintain projector at
proper operating range as function of outside ambient temperature.
• In Standby: All fans are off when projector is in standby and not running active loop-through on a Twin HDMI
inputs
•Temperature range for variable fan speed 5 to 40 degrees C
•Transition steps Smooth speed transitions with no abrupt audible changes
Automatic Color Filtering
Motorized yellow notch filter User selectable optical color switch (in or out) to enhance color space. Configurable per
channel
SLM™, Smart Lamplife Management: Constant (brightness) Lamp Output Management
• LiteLOC Automatically adjusts lamp output to maintain constant lumens setting within operating range of lamp.
• Lamp regeneration
• Smart power management (Power constant) 150W - 3000 hrs - 200W - 2000 hrs
• Smart single lamp mode: alternate lamp between startups
• Hot swappable lamp
Lens Shutter
Open: Light transmitted to projection lens
Closed: All light blocked - no light on screen
Activation Operation in less than 0.25 seconds.
Status LED
Status LED’s: Located at back of projector
• LED STATES
Lamp 1, Lamp 2:
• Off – Lamps are off
•Yellow – Lamp time has expired and lamp should be replaced
• Green – Lamp is on and operating correctly
• Flashing red – Lamp has malfunctioned
Power:
• Off – AC power is off
•Yellow – AC is present but projector is in standby