User manual

10.0 MAINTENANCE

R599791 - FORCE 3D User Manual 85

To use lamp OFF command

• In the lamp menu, select CHANGE LAMP. This will prompt for the old lamp serial number (if it was not previously

entered).

• Enter the new lamp serial number. NOTE: This action is not mandatory, it is recommended for accurate lamp

statistics to be archived.

Install the new lamp:

•Take precaution to align the new lamp properly in the correct orientation inside the projector.

• Press ﬁrmly to seat the lamps, ensuring the lamp is secure.

• Using the Phillips screwdriver and captive screws secure the lamp door and tighten the captive screw.

NOTES:

1) If the lamps were turned off with the OFF command, they will have to be manually turned on.

2) If the lamps were turned off by opening the door, then they will automatically turn on again when the door is

closed.