User manual
9.0 WEB USER INTERFACE
80 R599791 - FORCE 3D User Manual
NOTE: The scheduled tab is always selected by default on add.
Scheduled Event Window
3) Select the frequency option for the event by selecting either Once, Daily, Weekly, or Monthly.
NOTE: End Date is enabled when Daily, Weekly or Monthly repeat options are selected.
4) Click within the Start Time field to open a calendar pop-up window.
5) Navigate to and choose a desired date. The selected date will populate the Start Time field.
6) In the field below the Start Time field, enter a start time in the format “hr:min:sec”. The default is the current
time.
7) Click Sync to set the computer and projector time to be the same; otherwise, the event will run based on the
projector time. NOTE: Synching the projector time to be that of your system time.
8) Enter a description of the scheduled event in the Description field. NOTE: Maximum of 100 characters.
9) Enter a serial command or a sequence of serial commands, with which you wish the projector to perform in the
Command String box.
If a GPIO command string is needed, click the GPIO Output Helper button for instructions on how to create
the command structure.
NOTES:
1) The Output field contains 7 blocks which refer to the 7 I/O pins on the GPIO connector. Pin 1 = +12V and Pin 5 =
Ground. These are not included.
2) Clicking a block toggles between H, L, and X.
3) If the Pulse check box is selected, those I/O Pins defined will pulse high or low. See Figure 4-15 GPIO Output
Helper.
See “Appendix: GPIO”, page 96 for detailed information.
GPIO Output Helper.
NOTE: Serial Representation box is read only.
Click the Help button for a description of special RTE commands available for adding loops and delays to the
command sequence.
Click the Test button to test the entered command string.
NOTE: If the test passed or failed, a green or red icon appears to the right side of the Test button as shown in Figure
below.
Test Buttons
10) Click Finish to create the added event.
NOTES:
1) The added event appears in the RTE Listing window. See Figure below “RTE Listing Window”.
2) To activate or deactivate one or more RTEs listed in the RTE Listing window, select or clear each check box in the