User manual

8.0 ADJUSTING THE IMAGE
64 R599791 - FORCE 3D User Manual
• LCD Backlight Timer
Set how long the LCD backlight stays on (in seconds) when in timer mode.
• LCD Backlight Level
Sets the LCD backlight brightness level. Maximum 25/Minimum 0.
•Auto Power up
If there is an AC power interruption, while Auto Power Up is enabled, the projector will resume operation in the same
state as it left off. If the lamps are on and an image showing when AC power is lost, the projector will automatically
power back up with the lamps on and an image will show when AC is restored.
•Auto Shutdown Enable
When Auto Shutdown Mode has been selected, and no projector activity has been seen for the activation timeout
period, the projector will enter a power saving mode in which the lamps will dim and the shutter will close. If this
condition persists for an additional time-out period, the projector will automatically go to Standby mode. The
presence of any activity within this combined interval will cancel Auto Shutdown and return the projector to normal
operation.
•Turn off Image after (min)
This sets the activation interval (in minutes) for Auto Shutdown. If all activity (input signals, web or serial port activity,
key presses) is lost for this length of time, and Auto Shutdown is enabled, an Auto Shutdown cycle will begin.
• Enter Standby after (min)
This sets the interval (in minutes) between starting Auto Shutdown and entering Standby mode. Once Auto
Shutdown has been entered, and all activity continues to be absent for this interval, the projector will automatically
enter power Standby mode.
• Lamp Regeneration Start Time
For 24/7 operation, the lamp regeneration cycle is required or lamp life will be reduced. This control allows you to
set the time of day (in 24 hour format) when the regeneration cycle will start. In Dual Lamp mode, the cycle will be
performed on each lamp separately. The second lamp will wait for the first lamp to come back on before it begins the
cycle. In single lamp mode, the projector will go into Standby mode for the regeneration cycle. The regeneration
cycle will run for 15 minutes for each lamp. The lamp(s) must run for a minimum of 24 hours or the regeneration
cycle will be skipped.
• Over-temp Fan Assist
When enabled, this option will cause all fans to come on at full speed if any enabled thermal sensor has an over-
temperature fault. This may help to prevent an emergency shutdown if the extra cooling can bring the temperature
within limits before the shutdown occurs. The fan assist will cause increased noise levels due to the simultaneous
full speed operation of all the fans. Normal operation will resume when all over-temperature conditions are removed
or fan assist is turned off.
Date & Time
The current year-month-day, hour-minute-second. Changes here reset the projector’s real-time clock.
Menu Preferences
Adjust the appearance, content and/or location of on-screen menus and messages.
• Large Menu Font
Enter a checkmark to enlarge menus and their text. To adjust Menu Location to accommodate the increased menu
area.
•Menu Location
Use the pull-down list to choose a pre-defined default or customized location for the display of all on-screen menus.
To create a custom menu location:
1. Choose a preset that is closest to the desired location.
2. Adjust Horizontal Shift and Vertical Shift slide bars to move the menu to the desired location.
NOTE: Avoid locations too close to a corner or edge to prevent cropping of larger menus.
• Horizontal Shift and Vertical Shift
Shift your menus as desired, creating a customized menu location.
• Display Automatic Message Boxes
Enable or disable the pop-up of automatic message boxes. These are messages to the user that are not directly
triggered by user actions. Examples are signal information, function limitation or auto calibration message boxes.