User manual

8.0 ADJUSTING THE IMAGE
62 R599791 - FORCE 3D User Manual
Actual Frame Delay
Displays the actual frame delay reading. It is read only.
Full Screen Eye-Motion Filter
Check this control to apply the Eye-Motion Filter to the entire screen, rather than applying just to the edge blending
regions. Helps with posterization effects, sometimes seen in color ramps when viewing stereoscopic images.
Eye-Motion Filter
Adjust this filter to reduce saccadic eye-motion artifacts, sometimes noticeable in edge blending regions. Too much
filtering may result in loss of detail. For best results, adjust this setting while positioned at the nominal screen-
viewing distance.
Edit Secondary Channel Settings
When using Dual Input 3D, this allows you the option to independently control primary and secondary channel
settings, or to use the same setting for both links. By default, this control is unchecked, meaning any settings
applied to the primary input will also be applied to the secondary input. In this case, the secondary channel settings
cannot be set. When checked, the secondary channel settings become editable.
Main Input and Secondary Input
Select an input from the drop-down list.
Display 3D Message Boxes
Enable/Disable message boxes that are triggered by 3D setup. Note that no message box is shown in “Off” and
“Valid” state.
8.4 Configuration Menu
Use the Configuration menu to define general operating parameters and communications with other projectors and
equipment, and to access other advanced processing and image adjustments affecting overall performance. The
Configuration menu provides access to diagnostics, calibration tools and the Service submenu (password-
protected).
Configuration Menu
Language
Choose the available language to use in the projector’s menus. The change will take effect immediately.
Output Options - Submenu
• Screen Image Orientation
Select the on screen image orientation from Front, Rear, Front Inverted, and Rear Inverted.
• Output Resolution
Sets the output pixel resolution; default is the native resolution of the projector.
• Frame Locking
Select how the projector controls the output frame timing based on the input signal. When set to Framelock, output
image frames are locked to the input if possible. When Locked, the output is always locked to the primary input,
Configuration
1. Language
2. Output Options
3. Lens Settings
4. Power Management
5. Date & Time
6. Menu Preferences
7. Communications
English
8. Geometry & Color
9. Diagnostics & Calibration
10.Service
11.Option Card Settings
12.Dynamic Iris