User manual

5.0 REMOTE CONTROL
R599791 - FORCE 3D User Manual 29
Remote Keypad
Remote Keypad Commands
•Power ON/OFF
Press and hold POWER for two seconds or press twice quickly to action the projector ON or OFF. Or press and
release POWER followed immediately by UP ARROW KEY (ON) or DOWN ARROW KEY (OFF) to guarantee the
correct action (useful if you are unsure of the present state). NOTES: 1) After powering down, the lamp cooling fan
remains on for approximately five minutes to cool the lamp. 2) Avoid turning the projector back on until it has been
off for a few minutes. Hot re-strikes of the lamp will reduce lamp life.
•Test
Steps forward through all internal test patterns. After stepping past the last test pattern, you will return to current
input.
Press TEST and then cycle by using the UP ARROW KEY and DOWN ARROW KEY arrow keys, to cycle in either
direction through the test patterns. Press EXIT to return to the current input.
Input Slots
Focus
Zoom
Lens H
Lens VOSD
Swap
Input
PIP
Slot 1
Slot 2
Slot 4Slot 3
Power
Test Shutter
Auto
Menu Exit
Laser
ProjChannel
Gamma Bright
Contrast
Help
Func
10+
13
46
79
2
5
8
0
?
[Auto]matic image settings
Select active [Input Slot]
Display [Menu]
[Power] On or Off
[10+] button:
[Exit] to previous menu
Navigation buttons
[Func] button:
Numbers keys
[Confirm] button
Lens control:
[Focus], [Zoom] and [Offset]
Display [Test] pattern
[Gamma] Adj.
[Contrast] Adj.
[Bright]ness Adj.
Select Picture mode
[Help] button:
Open or close [Shutter]
between 99 [Channel]
Hide or show [OSD]
[Swap] button
Swap Main and PIP image
Select a [Projector]
in a multi projector install
Enter a special code
or - for negative value
Enter 0 digit or add 10
to the current value
Display help context
Select active [Input] on slot
Tu rn [PIP] On or Off