User manual

4.0 CONNECTING SOURCES

R599791 - FORCE 3D User Manual 27

This card accepts and decodes standard deﬁnition (SD) video. This includes CVBS (composite video), SVideo, and

component sources. This card supports as many as 6 video signals, four of them on BNC connectors and two on 4-

pin mini-DIN connectors. Each mini-DIN connector accepts 1 S-Video signal. The ﬁrst BNC accepts composite

video (only), while the remaining three BNC’s can be grouped to allow one of the following combinations:

•3 CVBS sources on 4, 5 & 6

•1 CVBS source, 1 S-Video source: Luma (Y) connected to 4(Sy) and Chroma (C) connected to 6 (Sc)

•1 YPbPr source: component signal on 4 (Pr), 5 (Y) & 6 (Pb)

NOTE: The video decoder input card has 8 LED indicators. The PWR LED indicates that the module is installed

properly, and has been successfully conﬁgured. The YPbPr LED indicates that a valid component signal has been

detected on inputs 4, 5, and 6 (Component input grouping must also be selected in the projector’s menu).

The remaining LEDs are each associated with one of the inputs, and indicate a valid signal has been detected on

that input.

Standard Video input board

1 - CVBS

PWR

Standard Video Input

2 - SVID

YPbPr

3 - SVID

4 - Pr/R/Sy

CVBS

5 - Y/G

CVBS

6 - Pb/B/Sc

CVBS