User manual

3.0 GETTING STARTED
R599791 - FORCE 3D User Manual 23
Projector state LEDs LED state
Hard Boot All All Leds amber - means please wait
Standby Mode
Lamp 1 & 2 Off - lamps are off
Power Amber AC is present but projector is off
Shutter
Green - shutter is open
Amber - shutter is closed
Warm-up (Powering ON from standby) All LEDs cycle grenn from left to right
Normal operation
Lamp 1 & 2
Amber - lamp time has expired and lamp
should be replaced
Power
Green - shutter is powered up and
operating normally
Shutter
Green - shutter is open
Amber - shutter is closed
Cool Down All Leds cycle amber from left to right
Error
Lamp 1 & 2
Amber - lamp time has expired and lamp
should be replaced
Flashing red - lamp has malfunctioned
Power
Flashing red - error has occurred. Details
are displayed on the status display
Software upgrade in progress All
the pattern will alternate between:
Amber, Off, Amber, Off and
Off, Amber, Off, Amber
Lamp regeneration in progress
Lamp 1 & 2
Flashing Green - the lamp is being
switched off for its regeneration period to
extend lamp life (15min every 24 hours)
Power
Green - on
Amber - standby
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
• The Status LEDs are cycling green
• The LCD displays the warning "Image Processor Upgrading"
• The LED on the Image Processor card flashes green
• The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be
removed.