Quick Start Guide

3
CLR-C1-SMK Indicator Summary
Normal
Operation
Action Red LED Yellow LED Sounder
Power Up Insert Battery 1 Flash 1 Flash Off
Standby Off Off Off
Sensing Fire Rapid
flashing
Off Full sound
Test Mode Action Red LED Yellow LED Sounder
Test Smoke
Alarm
Press Button Rapid
flashing
Off Full sound
Alarm Hush Action Red LED Yellow LED Sounder
Silence Sounding
Alarm
Press & Release
Button
1 flash
every 8 sec
Off Off for 10
mins
Silence Low
Battery
Press & Release
Button
Off Off for 12
hours
Off for 12
hours
Silence Faulty
Sensor
(only possible once)
Press & Release
Button
Off
2 flashes every
48 seconds
Off for 12
hours
Silence End of
Life Indication
(up to 30 days)
Press & Release
Button
Off Off for 72
hours
Off for 72
hours
Fault Mode Action Red LED Yellow LED Sounder
Low Battery Off
1 flash every
48 seconds
1 beep with 1
Flash
Faulty Smoke
Sensor
Off
2 flashes every
48 seconds
2 beeps with 2
Flashes
Faulty Heat
Sensor
Off
2 flashes every
48 seconds
2 beeps with 2
Flashes
End of Life Off
3 flashes every
48 seconds
3 beeps with 3
Flashes
Contaminated
Chamber
Off
4 flashes every
48 seconds
Off
Diagnostic
Mode
Action Red LED Yellow LED Sounder
Alarm OK Press & Hold
Button
Rapid
flashing
Off Full sound
Low Battery Press & Hold
Button
Off 1 flash then
rapid flashing
1 beep then
full
sound
Fault Sensor Press & Hold
Button
Off 2 flashes then
rapid flashing
2 beeps only
End of Life Press & Hold
Button
Off 3 flashes then
rapid flashing
3 beeps then
full sound
Contaminated
Chamber
Press & Hold
Button
Off 4 flashes then
rapid flashing
4 beeps then
full sound
Alarm
Memory
Action Red LED Yellow LED Sounder
24 Hour Memory
2 flashes
every 48
seconds for
24 hours
Off Off
Long Term
Memory
Press & Hold
Button
Rapid
flashing
Off Rapid chirping
CLR-C1-SMK Indicators explained Normal Operation
Power Up
Twist off the Alarm from the mounting plate (see Quick Start Guide).
Remove the battery tab to power the Alarm, the red LED will flash
once followed by one flash of the yellow LED to indicate that the
Alarm has been powered successfully and is now in standby mode.
Standby
In standby mode, there are no active visible or audible indications
to the occupant. To confirm that the Alarm is operational perform
a weekly button test.
Weekly Button Test
Press and hold the test button and verify that the red LED flashes
rapidly and the Alarm ramps up to its full sound.
Sensing Fire
As soon as the Alarm senses smoke it will go into Alarm (along
with any interconnected Alarms).