Quick Start Guide

Operating Temperature : 40°F to 100°F
Humidity Range : 15% to 95% R.H. (non-condensing)
Audible Alarm : >85dB(A) at 3m (10ft) minimum
Current Drain : Typical 9µA Standby
Heat Sensor Fixed Rating : 135°F +/- 5°F
Heat Sensor Rate of Rise : >104ºF@15ºF / min
Dimensions: 4.7” x 1.8”
Weight (grams): 0.46 lbs
FCC / IC Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
Per FCC 15.19 (a) (3) and (a) (4), This device complies with
part 15 of the FCC Rules. Operation is subject to the following
conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesirable operation.
Per FCC 15.21, The user manual or instruction manual for an
intentional or unintentional radiator shall caution the user that
changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any
interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de
licence standard RSS (s). Son fonctionnement est soumis aux
deux conditions suivantes: (1) cet appareil ne doit pas
provoquer d'interférences et (2) cet appareil doit accepter
toute interférence, y compris celles pouvant causer un mauvais
fonctionnement de l'appareil.
In accordance with FCC requirements of human exposure to
radio frequency fields, the radiating element shall be installed
such that a minimum separation distance of 20 cm is
maintained from the general population.
FCC: 2ABBZ-RF-UTSMK-433
IC: 11817A-RFUTSMK433
This Class B digital apparatus complies with Canadian ICES-3B.
17