Quick Start Guide

12
SELF TAPPING
SCREW
2 to 3 mm
7. Press the Test button on each Alarm
to ensure that the Alarm works (see
Figure 7).
Install all the other Alarms
similarly.
Smoke Alarm
Figure 7
Tamper Proofing the Alarms
The Alarm can be made tamper-proof to prevent unauthorized
removal of the Alarm.
Break off the small pillar on the base as shown in Figure 8a. To
remove the Alarm from the ceiling it is now necessary to use a
small screwdriver, to release the catch (push catch towards the
ceiling) and then twist off the Alarm (see Figure 8b).
If necessary, it is possible to further secure the Alarm by using
a 1/8” diameter x 1/4” long self-tapping screw (not supplied)
to firmly lock the Alarm and its’ mounting plate together (see
Figures 8c and 8d).
Figure 8a
How to Tamperproof
BREAK OFF
SMALL PILLAR
Figure 8b
How to Remove
PUSH UP CATCH & TWIST
ALARM ANTI-CLOCKWISE TO REMOVE
Attach the Alarm to the mounting plate.
Line up the screw (not supplied) on the “U” shaped recessed
area shown in Figure 8c and install screw until fully secured.
To remove the Alarm from the ceiling, remove the screw first,
and then twist off counterclockwise.
Figure 8c Figure 8d
6 to 8 mm