Installation Instructions
Table Of Contents
- Table of Contents
- 1. Read This First
- 2. Carbon Monoxide – The Silent Killer
- 3. Where to Place CO Alarms
- 4. Installation
- 6. What to do when the alarm sounds
- 7. How to Protect your Family
- 8. Technical Specification
- 9. Getting the CO Alarm Serviced
- 11. Limitations of CO Alarms
- 12. Troubleshooting
- 13. Display & Indicator Summary
15.
4. Installation
Warning: The Installation of this apparatus should not be used as a substitute for
proper installation, use and maintenance of fuel burning appliances including
appropriate ventilation and exhaust systems.
4.1 Installation Procedure
1. Select a location complying with the advice in
Section 3.
2. Remove the mounting plate from the packaging/
Alarm.
3. Place the mounting plate on the ceiling/wall
exactly where you want to mount the Alarm. With
a pencil, mark the location of the two screw holes.
4. Taking care to avoid any electrical wiring in the
ceiling, drill holes using a 13/64” (5.0mm) drill bit
through the center of the marked locations. Push
the plastic screw anchors provided into the drilled
holes. Screw the mounting plate to the ceiling/
wall.
5. Alternatively, if desired, the CO Alarm will also
free stand on a flat surface with the mounting plate
attached.
Figure 4
6. If using the RF feature, ensure the RF module is fitted correctly into the base of
the Alarm. For further advice on the RF installation, see the corresponding booklet
for the RF Module.