User's Manual

Wireless Recessed Sensor—Installaon Instrucons
Recessed Wireless Sensor and Accessories
1 - RF-RDWS-AAA 1 - RF-RDWS Magnet 1 - Baery ( CR2 3V) Instrucons
Doc # I-RF-RDWS-AAA Rev. A Sep 2015
Mounng the Transmier:
1. Verify mounng locaon before drilling any holes,
the area must be able to accept an 11/16” hole to a
depth of 2 1/4” for the sensor and 5/8” for the mag-
net
2. The holes must be drilled directly across from each
other to ensure the magnet and sensor operate
properly
3. Using an 11/16” drill bit drill the hole for the magnet
rst, aer drilling the magnet hole mark the locaon
directly across for the sensor hole.
4. The magnet and sensor are slightly larger than the
drilled hole to ensure a snug t, a small amount of
roung the hole may be required
5. Push both magnet and sensor into mounng holes.
Programming:
1. Remove the cap from the sensor by using a screw-
driver and twisng the cap
2. Pull the baery tab out to power the sensor
Note: The sensor should
be mounted in the door
and the magnet in the
frame.
Carefully pull out baery tab to power the sensor
Mount in
top or side
of door
Wireless Recessed Sensor—Installaon Instrucons
Recessed Wireless Sensor and Accessories
1 - RF-RDWS-AAA 1 - RF-RDWS Magnet 1 - Baery ( CR2 3V) Instrucons
Doc # I-RF-RDWS-AAA Rev. A Sep 2015
Mounng the Transmier:
1. Verify mounng locaon before drilling any holes,
the area must be able to accept an 11/16” hole to a
depth of 2 1/4” for the sensor and 5/8” for the mag-
net
2. The holes must be drilled directly across from each
other to ensure the magnet and sensor operate
properly
3. Using an 11/16” drill bit drill the hole for the magnet
rst, aer drilling the magnet hole mark the locaon
directly across for the sensor hole.
4. The magnet and sensor are slightly larger than the
drilled hole to ensure a snug t, a small amount of
roung the hole may be required
5. Push both magnet and sensor into mounng holes.
Programming:
1. Remove the cap from the sensor by using a screw-
driver and twisng the cap
2. Pull the baery tab out to power the sensor
Note: The sensor should
be mounted in the door
and the magnet in the
frame.
Carefully pull out baery tab to power the sensor
Mount in
top or side
of door