Safety Instructions

4 / 6 DOC ID – 1987 • Rev 03
Wiring
The graphic below details the module wiring.
Figure 1: Wiring diagram
(1) 12 VDC Backup battery connection
(1.a) Negative wire (-)
(1.b) Positive wire (+)
(2) 16 VDC Power supply connection
(2.a) Positive wire (+)
(2.b) Negative wire (-)
(3) 12VDC Auxiliary Power Output 1
(3.a) Positive wire (+)
(3.b) Negative wire (-)
(4) 12VDC Auxiliary Power Output 2
(4.a) Positive wire (+)
(4.b) Negative wire (-)
(5) Tamper input
(6) Wired zone N/O loop
(7) Wired zone N/C loop
Note: When wiring a sensor that also has a tamper output, the alarm output and tamper output should be wired in series so that
the zone will trigger on either a motion or tamper event.