Specifications

ManualsBrandsCIMCON ManualsElectronicsPhotocontroller

Installation and Commissioning Procedure

For iSLC3100-7P

CIMCON Lighting, Inc.

ISLC3100-7P

Overview:

CIMCON’s iSLC-3100-7P is an intelligent wireless lighting controller with exceptional fault tolerance and a multitude

of features. Each iSLC-3100-7P provides intelligent on/off switching, dimming control, GPS, highly accurate power

metering, analog and digital sensor inputs and constant status and health monitoring of your lighting fixtures.

Each CIMCON iSLC-3100-7P is a highly intelligent stand-alone device that utilizes the latest developments in self-

organizing, self-healing, wireless technologies. Proper operation and execution of a light’s schedule is not dependent

on network communications.

Details installation and commissioning procedure is provided in subsequent sections.

RF Radio Zigbee 2.4GHz Specification:

CIMCON’s iSLC-3100-7P is having Zigbee 2.4Ghz radio for the wireless network connection, with the below

specification.

• 2.4 GHz, IEEE 802.15.4 RF

• Data Rate: 250 kbps

• Receiver Sensitivity: -104 dBm

• Transmit Power: +20 dBm

• Open Field Range: 5000 ft/1.5 km

• Network Type: Self-forming mesh network

• Network Fault Tolerance: Self-healing mesh

• Data Protection: 256-bit AES encrypt

• Hardware: IEEE 802.15.4-2003 CS MA-CA algorithm3

• Operational channel: Channel 11 to 25

• 2.4GHz Zigbee radio produces an O-QPSK-modulated signal using the analog front end and digital baseband.

Page 1

Summary of content (6 pages)

PAGE 1
Installation and Commissioning Procedure For iSLC3100-7P CIMCON Lighting, Inc. ISLC3100-7P Overview: CIMCON’s iSLC-3100-7P is an intelligent wireless lighting controller with exceptional fault tolerance and a multitude of features. Each iSLC-3100-7P provides intelligent on/off switching, dimming control, GPS, highly accurate power metering, analog and digital sensor inputs and constant status and health monitoring of your lighting fixtures.
PAGE 2
Installation Procedure ISLC3100-7P Details installation and commissioning procedure: Place the Photocontroller into the 7-pin NEMA receptacle and rotate it clockwise to lock. Fig.
PAGE 3
Installation Procedure ISLC3100-7P Fig.
PAGE 4
Installation Procedure ISLC3100-7P The cables protruding from the receptacle have following function as mentioned into table. Once the Photo-controller is installed and luminaire is powered ON then depending on the daylight condition Lamp will operate. In the Lab environment, you can just cover the cap with cloth or by hand and see the Lamp turning ON if wired correctly and if you remove the cloth, it will turn OFF.
PAGE 5
Installation Procedure ISLC3100-7P the center of the receptacle/socket. Rotate to the new position and retighten screw. Do not rotate receptacle/socket over 360 degrees because you can twist receptacle/socket wires. Eventually stripping the insulation and cause the fixture to fail. • To check operation during the daylight hours, cover the SLC’s photocell window (or top surface) completely to simulate darkness. FCC Warning statement: 15.19    This device complies with Part 15 of the FCC Rules.
PAGE 6
Installation Procedure ISLC3100-7P FCC RF Radiation Exposure Statement: Mobile Device This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Canada (IC) statement: Labeling requirements for Industry Canada are similar to those of the FCC.