Instruction Manual

SPENCER Instruction Manual – DEC2014 Pag. 9
5. Remember use only FLAT NOSED BULLETS. You must hold the rifle at an
angle so that the cartridges slide down the magazine instead of dropping in.
6. After all rounds have been placed into the magazine well, insert the magazine
tube into the magazine well until the magazine tube base is even and 90
degrees to the right of the butt plate.
7. Then rotate the magazine tube base 90 degrees to your left.
FIRING
1. Place your protective eyewear and ear protection on.
2. Point the rifle in a safe direction.
3. Move the lever to its down most position. The breechblock will then pick up a
round from magazine well.
4. Bring the lever back up to the up most position. The round is now chambered.
5. Put your rifle to your shoulder and aim at the intended target.
6. Pull the hammer back two clicks.
7. Place finger on the trigger and squeeze the trigger.
8. After the shot is fired, pull the lever down.
9. The empty case will have been extracted and fallen to the rear.
10. Pull the lever back up until the lever is all the way up and touching the rifle.
11. Now a new round will have been inserted into the chamber.
12. Tip: We have found that the Spencer functions best if the lever is moved
briskly through its downward and upward travel without hesitation between the
downward and upward strokes.
UNLOADING
13. Point the rifle in a safe direction with the muzzle pointing up.
14. Lower the lever to the full extent.
15. With the muzzle pointed down, in a safe direction, withdraw the magazine
tube, then elevate the muzzle upward and allow the unfired rounds to slide out
into your hand or a soft surface.