Instruction Manual

SPENCER Instruction Manual – DEC2014 Pag. 10
16. Visually inspect the chamber, magazine tube and magazine for any missed
rounds.
17. Replace the magazine tube.
DISASSEMBLY
1. Unload the rifle.
2. Remove the magazine tube from the magazine well. Unscrew the lever screw
13 (hinge pin) and the lever and breech block assembly out the underside of
the action (receiver). Use a hollow ground screwdriver of the correct fit to
avoid damage to the screw.
Disassembly of the breechblock:
1. Remove the block to lever screw located on the right, and separate the upper
and lower breech block assemblies. The lever will slide out of the lower
breech block right to left.
2. Removal of the transfer bar is done by unscrewing the transfer bar screw
located on the right side of the upper breech block. The transfer bar is
removed by sliding it to the right.
Disassembly of the lock plate mechanism is normally not necessary and should only
be done by a competent gunsmith.