Operating instructions

8 English
GjGGGjG
Use a 15-pin D-Sub cable or DVI-D cable to connect the LCD display panel set to the computer.
1 Plug the cable into the output socket of the
graphic board.
2 Plug the other end of the cable into the socket
[RGB] or [DVI-D].
3 Adjust the settings of the Monitor picture
corresponding to the settings for Monitor
operation. See “Settings” on page 10.
GjGGlGkGGjGpG
You can use the LCD display panel to connect DVD recorder/player and set-top-box. Connect the audio
and video cables from the external equipment’s output jacks to the LCD display panel input jacks, as
shown in the ¿gure. When connecting the LCD display panel to external equipment, match the jack
colours.
Connecting to External Devices
1 Plug the video cable according into the colours
to the output sockets of the external devices.
2 Plug the other end of the video cable according
to the colours into the [Y, Pb, Pr] sockets on the
LCD display panel.
GjGzGkG
You can use the connections described parallel . On how to select the desired source see “Select
Source” on page 20 and “Select Signal Source for PIP” on page 20.
If the LCD display panel does not receive any signal, adjust the output of the
computer. For information on how to setup the computer, refer to the
corresponding manual of the computer.