Service manual

7 – 26
3) Remove the four screws and open the Rear Panel.
4) Remove the CT1. [See section “
7.3-10”]
5) Cut the snap band and remove the cables. Disconnect the three connectors CN1-3 on the PCB3.
Remove the three screws and the three cables. Remove the terminal.
6) Remove the 11 screws and PCB3 unit.
 Take care about the shape of the screw when you replace PCB3.
1
1
1
1
2
1
3
3
3
4
4
4
4
2
CN3
CN2
CN1
3
2
2
2
1
TRANSTIG 200 Pi
MAINTENANCE
SERVICE MANUAL