Service manual

7 – 24
7.3.18 C103 “Capacitor” and L102 “Reactor” V
1) Remove the Side Panel. [See section “6.1-1”]
2) Remove four screws, six terminals. Remove the C103 and L102.
Note : When C103 is installed again, it is a thing fixed to former place on PCB3 by RTV silicon rubber.
7.3.19 L103 “Reactor” VX[U
1) Remove the Side Panel. [See section “6.1-1”]
2) Remove the L102. [See section “
7.3-18”]
3) Cut off two snap bands and remove one screw, three terminals.
2
2
1
3
3
1
2
TRANSTIG 200 Pi
MAINTENANCE
SERVICE MANUAL