Service manual

7 – 15
7.3.8 D2 and D3 “Secondary Diode” V\
1) Remove the Side Panel. [See section “6.1-1”]
2) Remove PCB3 (WK-5569) and T1. [See section “
7.3-3”]
3) Remove six screws and then detach the D2 and D3.
 Do not have the wrong direction of the diodes when reinstalling.
 Before installing a new diode, apply a uniform coat of silicone compound (Shinetsu Silicone G-747 or
equivalent) on the base.
7.3.9 C.C. “Coupling Coil” and FCH1 “Reactor” V
1) Remove the Side Panel. [See section “6.1-1”]
2) Remove the Gas Tube. Remove the two bolts, two toothed washers, and the terminal.
1
1
2
2
1
2
2
2
1
SERVICE MANUAL
MAINTENANCE
TRANSTIG 200 Pi