Instruction Manual

20675-01 Rev 02

9.5.1.2 Operating Transmitter Display

In operating mode the display screen is split into three distinct

portions. The majority of the screen is devoted to a 2-line

measurement display as illustrated below. The bottom portion of the

screen will display status and configuration information.

Figure 52 Operating Transmitter Display

9.5.1.2.1 Line 1 / Line 2

Either line may be configured to display any of the values listed below.

Value Units

Flow Rate Users selectable list of values

Totalizer Users selectable list of values

Gas Volume Fraction Percent (%)s

Speed Of Sound Feet per Second (fps) or Meters per Second (mps)

Blank Line is blank

Table 8 Line 1 and Line 2 Values

9.5.1.2.2 Status Line

The code for information in the status line shown in Figure 52 are

defined as follows:

ID Characters Description Values

S 20 Status Messages See Status Messages Table below

Q 11 Quality Field See Quality Field Message Table below

M 4 Mode See Operating Mode Message Table below

C 1 Communications E – Ethernet or S – Serial

H 1 Hart Activity H – Hart Message received or [blank] – No Activity

W 1 Write Protect

W – Write Protected or

[blank] – Not Write Protected

E 1 Event Log Updated

! – Event Log Updated or [blank] – No change to

Event Log since last check

A 1 Activity |/-\ (Cycle changes indicate activity)

Table 9 Status Line Code

2281.5 gpm

2.016 %

SSSSSSSSSSSSSSSSSSSS QQQQQQQQQQQ MMMM CHWEA

Flow Rate

Entrained

Line 1

Line 2

Status Line