Owner's manual

Table of Contents
1 SCOPE ...................................................................................................................................1-1
2 MARKINGS.............................................................................................................................2-1
2.1 Transmitter [TB8-xx-xx-xx-03] for use with Sensor Head [SH-xxx-xx-xA-xxx-03]:................2-1
2.2 Sensor Head [SH-xxx-xx-xA-xxx-03]: ...................................................................................2-1
2.3 Transmitter [TB8-xx-xx-xx-04]:..............................................................................................2-2
3 ATEX ZONE 2 SPECIAL CONDITIONS OF USE RELATED TO THE SYMBOL “X”.............3-1
3.1 Transient Protection..............................................................................................................3-1
3.2 Electrostatic Charging...........................................................................................................3-1
3.3 Cable Glands ........................................................................................................................3-1
3.4 Control Drawings ..................................................................................................................3-1
3.5 Environment..........................................................................................................................3-1
4 STANDARDS..........................................................................................................................4-1
5 CONTROL DRAWINGS..........................................................................................................5-1
6 SPECIFICATIONS..................................................................................................................6-1
6.1 Electrical Parameters............................................................................................................6-1
6.2 Maximum Surface Temperatures..........................................................................................6-1
7 OPERATING CONDITIONS UNDER WHICH THIS PRODUCT MAY BE SAFELY USED....7-1
7.1 Scope....................................................................................................................................7-1
7.2 Hazardous Rating Location of Facility Where It Is To Be Installed.......................................7-1
7.2.1 System including TB8-xx-xx-xx-03 Transmitter.............................................................7-1
7.2.2 System including TB8-xx-xx-xx-04 Transmitter.............................................................7-1
7.3 Installation Site Ambient Temperature, Pressure, Humidity..................................................7-2
7.3.1 Temperature..................................................................................................................7-2
7.3.2 Barometric Pressure .....................................................................................................7-2
7.3.3 Humidity ........................................................................................................................7-2
7.4 Water Spray and Dust...........................................................................................................7-3
7.5 Explosive Gasses .................................................................................................................7-3
7.6 Condition of piping ................................................................................................................7-3
7.7 Chemical Environment..........................................................................................................7-4
7.8 Mains Power .........................................................................................................................7-4
8 SUPPLEMENTARY INSTRUCTIONS FOR SAFE ASSEMBLY AND INSTALLATION..........8-1
8.1 Use Control Drawing, Install Per Code .................................................................................8-1
8.2 Make Correct Terminal Block Connections...........................................................................8-1
8.3 Use Cable Glands and/or Conduit Entries............................................................................8-1
8.3.1 Selection of Cable Glands.............................................................................................8-1
8.3.2 Selection of Conduit Fittings .........................................................................................8-1
8.4 Wire With Power OFF...........................................................................................................8-1
8.5 Wire Securely to Terminals and Route Neatly ......................................................................8-2
8.6 No Foreign Objects...............................................................................................................8-2
8.7 Avoid Leaky Pipes ................................................................................................................8-2
8.8 Seal Sensor Head Cover ......................................................................................................8-2
8.9 Secure The Access Panel.....................................................................................................8-2
9 SUPPLEMENTARY INSTRUCTIONS FOR SAFELY PUTTING INTO SERVICE..................9-1
9.1 Prior to Applying Power ........................................................................................................9-1
9.2 Apply Power..........................................................................................................................9-1
9.3 Perform Setup.......................................................................................................................9-1
9.4 Verify Proper Operation ........................................................................................................9-1
10 SUPPLEMENTARY INSTRUCTIONS FOR SAFE USE (NORMAL OPERATION WITH NO
OPERATOR INTERVENTION).............................................................................................10-1
20909-01C Rev 04 Page i