Manual

20639-01 Rev 03

the Line 4 value press ‘ENTER’ and use the arrow keys to enter

the new value. Note: if an external pressure transducer that reads

pressure in ‘absolute’ values (e.g. PSIa, BARa, or KPaa is used an

altitude correction is not necessary.

• Press the ↓ key to scroll to ‘→Set Date/Time’ on Line 2. Press the

‘ENTER’ key and the current saved date and time will be displayed

on Line 4 of the display. Use the arrow keys (↑ and ↓ to scroll

through the values and ← and → to change character) to enter the

date and time. If possible, synchronize the date and time entered

to that of the process control data system. Note: Time is in 24-

hour format. Once the date and time have been set press the

‘ENTER’ key followed by the ‘BACK’ key.

• At this point ‘Basic Config’ is displayed on Line 1 of the display.

The user can re-enter this menu if desired by pressing the

‘ENTER’ key or by pressing the ↑ or ↓ arrows to move to other

Level 1 menus (see Table 12).

Entry of inputs to the other Level 1 menus is by the same process as

used in ‘Basic Config’.

The following table provides a template for recording the transmitter

setup for future reference.